Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated Pipes
Corrugated pipes are double-wall HDPE pipes with a ribbed outside and a smooth inside, used for non-pressure wastewater, stormwater drainage, and cable protection lines. Düzgünler Plastik offers SN4 and SN8 corrugated pipes and 13 fittings to complete the line, all in one category.
Corrugated Pipe (SN4 / SN8): Double-wall HDPE pipe with gasket joints
Corrugated Pipe Sleeve: Joins two pipes end to end
Corrugated Pipe Gasket: Seals the pipe inside the sleeve
Corrugated Insert Gasket: Seals fittings onto the pipe
45° Elbow: Gentle change of direction
90° Elbow: Right-angle turns
Corrugated Outlet Tee and Outlet C: Corrugated side branch on the main line
PVC Outlet Tee and C with PVC Outlet: PVC side branch on the main line
Corrugated Pipe Reduction: Joins pipes of different diameters
Corrugated Adapter and PVC Adapter: Transitions to other pipe systems
Corrugated Pipe Blind: Closes the end of a line
Short answer: choose SN4 for light loads and SN8 under roads and heavy traffic. SN is ring stiffness measured with the ISO 9969 method.
|
Criterion |
SN4 (4 kN/m²) |
SN8 (8 kN/m²) |
|---|---|---|
|
Load |
Gardens, fields, around buildings |
Roads, car parks, industrial sites |
|
Typical line |
Drainage, cable protection |
Sewer networks |
|
Pro |
Lower cost |
Higher crush resistance |
Domestic and industrial wastewater
Stormwater and surface water drainage
Cable protection for power and telecom
Road and infrastructure projects
Corrugated pipes are not for pressurised water; for drinking water and irrigation, see the HDPE PE100 Pipes category.
In industrial production since 1975 and plastic pipe production since 1996
First company in Türkiye to produce plastic column pipes for submersible pumps
Pipe and all fittings from one supplier, from its plant in Konya's 3rd Organized Industrial Zone
SN4 and SN8 ring stiffness classes.
Sleeve, pipe and insert gaskets, 45° and 90° elbows, outlet tee and C, PVC outlet tee and C, reduction, adapter, PVC adapter and blind end.
No. The gasketed end is pushed into a sleeve.
Yes, with a PVC adapter or PVC outlet fittings.
Send the diameter, SN class, length and fittings list to request a quote.
No; it is for non-pressure wastewater and drainage lines.
An outlet tee takes a corrugated branch; a PVC outlet tee takes a PVC pipe.
The ribbed outer wall carries load; the smooth inner wall helps flow.
|
Author: Düzgünler Plastik Technical Team — HDPE and U-PVC pipe production and quality control specialists. Source: ISO 9969 — Thermoplastics pipes, ring stiffness Contact us for a quote and technical information. |
For more information about our products and production processes, please contact us.